RocKI> Типа того. Но можешь как Накка попробовать вкладной заряд. Х/з правда почему оно работает. По-видимому из-за слабой теплопроводности пластик не успевает среагировать на нагрев за время работы ~1 c. Там еще и давление у него какое-то непонятное, но похоже очень небольшое. Нормальное там давление
This article describes the design, testing, performance and construction of a K class, KN/Sorbitol propellant PVC rocket motor with a total impulse of 2000Ns and whose thrust curve is flat compared to the characteristic curves achieved with other KN/Sorbitol propellant motors. The design of this motor draws upon the experience gained with the J/K motors, results from other experimenters and the burn rate data for KN/Sorbitol propellant compiled by Richard Nakka. As with the other motors of the PVC series, the motor uses readily available parts to simplify construction.
// Дальше — www.nakka-rocketry.net
но я ПВХ трубу не нашел, и попробовал на армированном полипропилене.
Массивность такой трубы конечно озадачивает. При внешнем диаметре 75мм, внутренний всего 50мм. Поэтому прогарать стенка не успевает, и запросто выдерживает время работы около 2,5-3сек.